Grey Spiral Classifiers For Mineral Separation And Sand Washing

The Spiral Classifier is available with spiral diameters up to 120″. These classifiers are built in three models with 100%, 125% and 150% spiral submergence with straight side tanks or modified flared or full flared tanks. All sizes and models are available with single-, double- or triple-pitch spirals.

The Spiral Classifier offers the greatest sand raking capacity of any classifier available.

The tank is heavy plate with strong structural base. The extra heavy shaft has an improved submerged bearing. The greatest improvements, however, are found in the drive-unit which has been strengthened and improved over all other classifiers. A specially designed classifier reducer eliminates the “over – hang” or cantilevered load normally found where the reducer shaft carries the pinion. The Classifier Reducer has an outboard bearing integral with the reducer base which provides positive alignment of the bevel gears.

The gears themselves are greatly improved as they are cast from metal patterns which have cut teeth. The accuracy of the patterns and the quality gear castings result in a cast-tooth gear of cut-tooth quality. The gears mesh smoothly, have greatly increased capacity and are noticeably more quiet than other spiral classifiers.

Spiral Classifiers are available in sizes up to 120″ diameter, three tank styles, single, double and triple pitch spirals, three degrees of spiral submergence —flexibility to provide a unit built for your job. Write for detailed recommendation on the correct size and type of Spiral Classifier to do your job economically and profitably.